I've purchased the Behringer FCB1010 midi foot controller with much anticipation as I've been dreaming of mulching my guitar and vocals live, BUT I'm having a little trouble implementing.
AM recognizes the device no prob and it is a breeze to Quick Map the controller parameters, but I can rarely get the FCB1010 to properly trigger an event as desired -- usually just no response at all, even though I can see (via the midi parameter dialogue) that it is mapped.
Two examples: LiveLooper: I will Quick Map pedal1 to Start, pedal2 to Next and pedal3 to End All. Fine. But when I try to perform with it, either different pedals will Start/Stop (but not with any consistency) or nothing happens at all.
2nd Example: S8Mixer: I will Quick Map mutes to corresponding pedals. Same basic result. Nada.
I have an Akai LPD8 midi pad controller, which I can use fine for the above examples, but obviously I can't control it with my feet very well ;-)
Could it be an issue with the FCB1010 only sending Program Changes (vs. CC) from the pedals? AM is recognizing them as PC's.
Ross, I LOVE your software and have been a user since I think v.54. Any suggestions are appreciated.