I searched the forum for an answer to this but I did not find one so I am writing a post looking for help.
I just installed the AudioMulch 2.1.0 trial on my MacBook Pro. On initial launch and when I tried to apply changes to the sampling rate from 44.1 kHz to 96 kHz in the Preferences I got the following error:
Internal PortAudio error (PortAudio error -9986)
I am using the Built-In audio card which can run up to 2 channels at 24bit/94kHz.
I looked online and found no information on this error. My system is installed on a recently zeroed out drive and has Live 8.1.5, Logic Pro 9.1.1 and MaxMSP 5.1.4 installed on it. All of which work fine.
Apple MacBook Pro
2 GHz Intel Core Duo
2 GB 667 MHz DDR2 SDRAM
OS X 10.6.4
Built In Audio
Thanks in advance for any assistance.